Router Network Cards

PCI 1104 WAN Adapter

Data rate: 155 Mbps per port

Port density: 4 full duplex

Interface support: SONET OC3 or SDH STM1

The PCI 1104-O3 WAN adapter is designed for use in routers or other products running Linux. The PCI 1104-O3 provides four OC3/STM1 SONET/SDH ports for packet-over-SONET/SDH (POS) applications. It also includes a high-performance embedded network processing unit (NPU) that accelerates packet processing for high-speed routing or monitoring applications.

The PCI 1104-O3 provides a 32-bit 33/66 MHz PCI bus interface that supports signaling at 3.3 or 5 volts. This high-speed PCI bus interface supports up to 2 Gbps throughput, and allows the card to operate at the higher bus speeds supported by some routers.

The PCI 1104-O3 takes advantage of the Wintegra WinPath 777 NPU. The 777 includes an integrated MIPs processor for board control and protocol processing, as well as a packet processing pipeline with four 200 MHz processing cores. The NPU is fully programmable, and can take advantage of new protocols and software features as they are developed.

Another important feature of the PCI 1104-O3 is its modular fiber optic transceivers. The PCI 1104-O3 uses SFP pluggable transceivers so each port can be configured to support any of the available fiber optic interfaces. Pluggable SFP transceivers include multi-mode fiber for short haul applications, intermediate reach single mode fiber for distances up to 15 km, and long reach single mode fiber for distances up to 25 km.

TECHNICAL SPECIFICATIONS

• PCI 2.2 compliant
• WinPath 777 NPU
• Four-stage packet processor
• 128 MB packet RAM
• 8 KHz Tx/Rx reference clock

Performance

• 32-bit 33/66 MHz PCI
• Low-latency PCI bus master
• 4 full duplex 155 Mbps ports
• SONET OC3 or SDH STM1

OC3 interface options

• Selectable SONET STS-3c or SDH STM-1
• LC duplex fibre
• Compliant with GR-253 and GR-499

SFP interface options

• Multimode fibre up to 2 km
• Single mode fibre up to 15 km
• Single mode fibre up to 25 km

Standards compliance

• PCI 2.2
• RFC 1619, 1661, 1662 and 2615
• ITU-T G.707 and 783
• Telcordia GR-253 & GR-1244

Model numbers for card and SFP options

• PCI 1104-O3 – 4-port POS OC3/STM1 card
• SFP-OC3-MM – Multimode transceiver for distances up to 2 km
• SFP-OC3-SM-IR – Single mode transceiver for distances up to 15 km
• SFP-OC3-SM-LR – Single mode transceiver for distances up to 25 km

Note: One SFP transceiver is required to connect each OC3/STM1 port.

For more information on our range of networking products, please contact Marketing