450b 2 x 2 Point-to-Point Wireless System

5Ghz 2-x-2-point-to-point-wireless-system
Inflink Antenna

Overview

The 450b 5Ghz 2-x-2-point-point-wireless-system from Case Communications is a highly diversified family of wireless Point-to-Point and Subscriber products which brings together a capacity up to 300Mbps with a rich set of features while being highly cost effective. It consists of the two sub-families:

  • 450b- Point to Point and Subscriber Stations Mid Gain Antenna (17dBi)
  • 450b Point to Point and Subscriber Station with High Gain Antenna (24dBi)

5Ghz 2-x-2-point-to-point-wireless-system key features

  • MIMO 2 x 2 (Multiple In,Multiple Out) innovative technology
  • Small form factor allows for an inconspicuous installation
  • Advanced Quality of service and advanced feature set
  • Reliable and robust design.

Typical Applications

  • 4G / LTE Backhaul
  • WISP (Wireless Internet Service Provider) Infrastructure backhaul
  • High Capacity ‘last mile’ access infrastructure
  • CCTV Backhaul and infrastructure
  • Building to building connectivity at Fast Ethernet or higher speeds for private and enterprise networks.
  • A Cost effective alternative for legacy microwave or wired leased lines
  • Can be used for subscriber and backhaul applications
  • Reliable back up for fibre lines, high speed FSO or millimetre wave links

Field proven performance

  • 300+ Mbps in a 40Mhz Channel
  • High gain  24dBi integrated antenna option  with a maximum range of 40km
  • Sophisticated automatic modulation and TX Power control algorithms

Sophisticated interference mitigation and frequency planning toolkit

  • Instant DFS (Dynamic Frequency Selection) technology allowing zero downtime dynamic frequency selection and a non-invasive spectrum scan.
  • Spectrum analysis tool supporting multiple modes for an in-depth review
  • GPS synchronization support
    125 kHz minimal centre frequency adjustment step
  • Multiple channel widths supported
  • 5Mhz, 10Mhz, 15Mhz, 20Mhz, 30Mhz or 40Mhz channels
  • New System on a Chip (SoC) enhances Packet Processing Power giving 4 times more power than previous products.
  • 3.5mm audio jack allows direct connection of headphones without the need to use adaptors.

5Ghz 2-x-2-point-to-point-wireless-system product specifications

 

Interface 
MAC (Media Access Control) LayerProprietary
Physical Layer2x2 MIMO OFDM
Ethernet Interface100/1000BaseT, full duplex, rate auto negotiated, 802.3 compliant
Protocols UsedIPv4, IPv6, UDP, TCP/IP, ICMP, Telnet, SNMP, HTTP, FTP
Network ManagementIPv4/IPv6 (dual stack), HTTP, HTTPS, Telnet, FTP, SNMPv2c and v3,
MTU1700 bytes
VLAN802.1ad (DVLAN Q-inQ), 802.1Q with 802.1p priority, dynamic port VID

Wireless Parameters 
Channel SpacingConfigurable on 2.5Mhz increments
Frequency Range4900 - 5925Mhz
Channel Width5Mhz, 10Mhz, 15Mhz. 20Mhz, 30Mhz or 40 Mhz
Ultimate Sensitivity-94dBm
Maximum Deployment RangeUp to 40 Miles(64Km)
Latency3 ~ 5Ms typically
GPS SynchronisationYes, synchronised by Access Point
Quality of ServiceDiffserve QoS
Transmit Power Range22dB dynamic range (EIRP limit by region) 1dB steps
Maximum Transmit Power+27dBm (MIMO combined V+H) (+22dBm @ 256 QAM)

Physical Layer 
MIMI2 x 2 MIMO OFDM
Ethernet Interface10/100Base-T, Full Duplex, rate auto negotiated, 802.3 compliant
Protocols UsedIPv4, IPv6, UDP, TCP/IP, ICMP, Telnet, SNMP, HTTP, FTP
Network managementIPv4/IPv6 (dual stack), HTTP, HTTPS, Telnet, FTP, SNMPv2c and v3.
MTU1700 bytes
VLAN802.1ad (DVLAN Q-inQ), 802.1Q with 802.1p priority, dynamic port VID

Performance  
Packets Per Second50,000 PPS
Modulation Levels AdaptiveMCSSignal to Noise required (SNR in db)
2XQPSK10
4X16-QAM17
6X64-QAM24
8X256-QAM32

Antenna Specifications  
Integrated Antenna Peak gainMID Gain 17dBiHigh Gain 24 dBi
3dB Beamwidth - Azimuth15 Degrees7 Degrees
PolarisationDual Linear H + VDual Linear H + V
Front to back Isolation>20dB>25dB
Cross Polarisation15dB15dB

450 Physical Specifications  
Antenna AccessoriesN / AOptional Radome
Surge SuppressionEN61000-4-5; 10 x 700us, 4Kv
EN61000-4-2: ESD 30kV Contact / 30kV Air
EN61000-4-5; 10 x 700us, 4Kv
EN61000-4-2: ESD 30kV Contact / 30kV Air
EnvironmentalIP55IP67
Temperature / Humidity-40c ~ +60C (-40F ~ +140F)
0-95% non-condensing
-40c ~ +60C (-40F ~ +140F)
0-95% non-condensing
Wind survival200Km / Hour (124Mph)200Km / Hour (124 Mph)
Dimensions (H x W x D) Including Mount12.5cm x 24.8cm x 12cm (4.9"x9.8"x4.7")45 cmx 28cm) (17.8" x 11.2")
Pole Diameter Range / Mechanical Tilt (w/included Mount)2.5 ~ 4.1cm (1" to 1.6") w / includes clamp to 5.7cm (2.25")2.5 ~7.6cm (1" ~ 3") +/1 20 degree mechanical tilt
Power consumption9 watts nominal, 12 watts peak9 watts nominal, 12 watts peak
Input Voltage20 ~ 32vdc20 ~ 32vdc
Mean Time Between Failures>40 years>40 years

Data Sheet

450b Point to Point Wireless Data Sheet (10 downloads)

Ordering Information

For more information please contact Case Communications