Key Features of the PIGE 10T 4S G – 14 Port Industrial Ethernet PoE Switch
- 10 x Gig Tx Ports, 8 x PoE, 2 x Tx
- L2+ features provide better management, security, including 802.1Q VLAN, Port Mirroring, Port Isolation, IGMP Snooping, DHCP Snooping, LlDP, PoE+ Management, IP Source Guard, ARP Inspection, Access Control Lists
- Support for Spanning Tree (802.1D) and Rapid Spanning Tree (802.1W)
- G.8032 ERPS Ring Protection.
- Jumbo Frames 9K Kilobytes
- Support for enhanced management through WEB, CLI, TELNET, SSH and SNMP
PIGE 10T 4S G Key Features Continued
- IPv6 Protocol
- 8Kv Electric surge protection
- Support for IEEE 802.3af PoE and IEEE 802.3at PoE +
- 48vdc (48~57vdc) Dual Power Supplies with input polarity protection
- Support for cable diagnostics
- Adjusts power depending on cable length
- Port Mirroring up to N-1
- IP40 Housing
- Installation DIN rail, Wall mounting
| Technical Specifications | |
|---|---|
| Performance | 20.83 Million Packets Per second |
| Backplane | 256Gbps |
| Interfaces | 8 x 10/100/1000Mbps PoE / PoE+ 2 x 10/100/1000Mbps Tx 4 x 100 / 1000 SFP |
| Layer 2 Switching | |
| STP | 802.1D Spanning Tree Protocol |
| RSTP | 802.1W Rapid Spanning Tree Protocol |
| G.8032 ERPS | G.8032 Ethernet Ring Protection Switching |
| LACP | Link Aggregation Protocol (IEEE 802.3ad) up to 7 groups 14 ports per group |
| VLAN | Up to 4,000 simultaneous VLANS, port based, Tag based |
| IGMP v1 / v2 | IGMP limts bandwidth hungry multicast traffic allowing only the requester to receive the data |
| Security | |
| SSH Secure Shell | SSH Secures Telnet Traffic into or our of the switch |
| SSL Secure Socket Layer (HTTPS) | SSL Encrypts the HTTP traffic allowing advance secure access to browser based managers |
| Port Security | Locks MAC Addresses to ports, and limits the number of learned MAC Addresses |
| DHCP Snooping | Prevents unauthorised configuration and use of IP Addresses providing support for IP Source Guard and ARP detection |
| IP Source Guard | Prevents datagrams with spoofed addresses from entering the network |
| ARP Inspection | Prevents ARP Spoofing attacks and ARP |
| Storm Control | Prevents broadcast, multicast or unicast storms on a port. |
| ACL (Access Control List | Support for 256 entries. drop or rate limitation based on source and destination MAC, VLAN ID or IP Address protocol, DSCP / IP Precedence, TCP / UDP Source and Destination ports, 802. Ip priority, Ethernet type, Internet Control Message Protocol 'ICMP', IGMP packets, TCP Flags. |
| Quality of Service | |
| Hardware | Support for 8 hardware queues. |
| Scheduling | 8 Class Service per port, strict priority and Weighted Round-Robin 'WRR@ |
| Classification | Ingress policy; Egress shaping, and rate control per VLAN per port, and flow based |
| Management and diagnostics | |
| Web Gui Interface | Built in switch configuration, for browser-based device configuration (HTTP / HTPS), Support configuration, system dashboard, maintenance and monitoring. |
| Dual Image | Provide independent primary and secondary files for back up during upgrades |
| Firmware Upgrade | Web Browser upgrade via 'HTTP / HTTPS', TFTP and via console port. |
| Port Mirroring | Monitoring of a port via a 2nd port, using a network analyser or RMON Probe |
| Other Management | Single IP address for management, 'HTTP / HTTPS' ; SSH' RADIUS, DHCP Client, SNTP, Cable diagnostics; Ping; system log; Telnet Client 'SSH' Secure Support. |
| Green Ethernet (EEE) | |
| Green and Energy Saving Ethernet (EEE). | Compliant with IEEE802.3az Energy Efficient Ethernet Task Force. Automatically turns off power on Gigabit Ethernet RJ45 ports when detecting the link is down or the client is idle. Active mode is resumed without the loss of any packets when the switch detects the link is up. |
| Cable Length Detection | The switch adjust the signal strength based on the cable length. Reducing the power for shorter length cables. |
| General | |
| Jumbo Frame | Support for frames up to 9 Kilobytes |
| MAC Table | Up to 8K MAC Addresses |
| LLDP | Link Layer Discovery Protocol used by network devices to advertise their identities, capabilities, and neighbours on IEEE 802.3 local area network |
| Power Over Ethernet | |
| PoE Standards | IEEE802.3af Power Per port 15 watts, IEEE 802.3at power per ports 30 watts |
| PoE Ports | 8 PoE end-span |
| Environmental | |
| Dimensions | 165 x 148 x 54mm |
| Weight | 1.1Kg |
| Operating Temperature | Operating Temperature -40C~+80C. |
| Storage Temperature | Operating Temperature -40C~+85C. |
| Operating Humidity | 10% ~ 90% relative non-condensing |
| Certifications and Standards | |
| EMC | FCC Part 5, CE / EMC / LVD EN55024:2010+ A1: 2015, EN61000-3-2: 2014, EN 61000-3-3: 2013. |
| EN61000-4-2 (ESD), EN61000-4-3 (RS). EN61000-4-4 (EFT), EN61000-4-5 (Surge). EN61000-4-6 (CS), EN61000-4-8, EN61000-4-11, EN50532: 2015/AC: 2016-07 | |
| Vibration | IEC 60068-4-11 |
Downloads and Ordering Information
Datasheet PIGE 10T 4S-G Datasheet (905 downloads )
How to configure ERPS Ring Protection on Case Communications Industrial Ethernet Switches Configuring ERPS on Case G Series Switches (1777 downloads )
Part Number PIGE 10T 4S G
Description: 14 Port Industrial Ethernet PoE Switch, with 8xGigabit PoE+ Ports 2xGigabt Tx ports, 4xGigabit SFP ports, G.8032, STP, RSTP Ring protection, SNMP Management, Fanless operation -40C~+80C